On my recent family vacation to Walt Disney World, the park was beginning to get ready for the holiday season and decorations were everywhere you looked. I spotted some amazing wreaths, so once I got home I wanted to try to make one of my own. My wreath cost me under £5/$8 to create and looks beautiful hanging on my front door.
You will need:
You will also need a hot glue gun or other strong adhesive.
Position the three rings into a classic Mickey Mouse shape. I used a cutting board with guidelines to help place both small rings at the same height. Then use a hot glue gun to stick them in place. Make sure you do not allow the glue to dry with the wreath lying flat or it will end up glued to the surface (I know this from experience). The glue dries quickly, so I found it easiest to simply hold the wreath for a couple of minutes until it was no longer tacky.
Once the glue has fully dried, you can paint the whole thing green. It will eventually be entirely covered in the felt but I chose to paint mine just in case any small gaps showed through.
Cut out the felt leaves. Each of mine measured approximately 1″x1.5″ and you will need several hundred. I used around four letter paper sized sheets of felt and the cutting out probably took about two hours in short sessions. I sat and caught up on Serial while I cut mine out. Don’t worry about making them all identical—have you ever seen a real holly bush with perfectly uniform leaves? However many you cut out though, you’ll probably need more. A lot more.
Start gluing the leaves onto the wreath shape. I used a hot glue gun but any kind of strong adhesive should work just fine. Try to make sure to overlap the leaves so you don’t leave any gaps. To make the wreath look thicker, layer leaves on top of one another. I tried to avoid being TOO regular with placement but also kept some order so it didn’t look completely haphazard.
Position the red buttons randomly around the wreath. I used a mixture of single heart shaped buttons, and circular buttons grouped in threes to create more Mickey Mouse shapes. Glue these in place on top of the felt leaves.
Attach a hook or string for hanging; where to put this will depend on where and how you want to hang your wreath. I used hot glue to attach a Mickey-shaped paper clip to the back, then strung Christmas-colored twine through it for hanging before adding an extra bit of glue for good measure. The finished wreath is very lightweight so nothing too heavy duty is required.
You’re done! It’s probably worth noting that these wreaths are not at all weatherproof and thus need to be kept indoors. You could also use foam rings that are rounded rather than flat backed and continue the design all the way around to the back – this would work well if it was to be hung on a glass door; just increase the quantity of felt and buttons to suit.
If you make your own wreath then please share it on our Facebook page.
This post was last modified on December 13, 2017 10:23 pm
At the dawn of the Magistrate's rule, a crisis in Metropolis sends Superman across the…
Five tales from iconic creative teams including the DC debut of David Aja and an…
What has become of the Legion as we travel further into the 31st century?
Jackson Hyde will go to hell and back to bring Andy Curry back to her…